PC/104 Low Power Intel™ 486DX
 HiRel cpuModule™ & Controller with Digital I/O
CMK6486DX66HR 
On-board Isolated ISO11898 CAN Bus, Two Serial Ports, SSD, ISA Expansion Bus

Operating Temperature -40° to +85°C

	Featuring Fail Safe & Quick Boot Modes
COM2			COM1
CAN bus Digital I/O			Parallel
			Utility: Keyboard Speaker Battery Reset
	Power
	CMK6486DX66HR-32  cpuModule™ Solder-tail expansion bus, vertical  I/O & feed-thru I/O connectors available on request
ISA (PC/104)
	with standard Heatsink installed
	Rugged Fanless IDAN™ & HiDAN™ Configuration -40°C to +85°C

• 66 MHz @ 3.3 volt 486DX processor Intel™
• 16 or 32MB surface mount DRAM on-board
• Rugged Passive Heatsink
• Passive Structural Heatsink in
  IDAN^™ and HiDAN^™ System Configurations
• Intel 82527 CAN controller
• Up to 1 MB/s data rate
• Isolated ISO11898/2/ CAN interface 
• Isolation up to 750Vac-rms
• 82C251 CAN transceiver
• Single power-supply voltage 
• 32 Pin SSD Socket Supports: SRAM, Flash & EPROM
• Nonvolatile Configuration & Flash BIOS with Quick Boot Mode Installed
• Software selectable RS-232/422/485
• Virtual Device Mode and Flash BIOS
• Windows® CE Certified
• Mating Connectors
• Standard 10-pin 0.1" DIL header (Utility, COM1, COM2, CAN, DIO)
• Standard 8-pin 0.1" DIL header (Power)
• Standard 26-pin 0.1" DIL header (Parallel)

Features:

• Complete PC-compatible motherboard
• Stackable 104-pin PC/104 AT bus
• Math coprocessor
• 16KB internal cache
• 1024-bit EEPROM (user bits)
• Real time clock (external battery required)
• Watchdog timer
• Fixed 1.2 second timeout
• 7 DMA channels
• 14 interrupt channels
• 3 timer/counter channels
• 32-pin DIP socket for Solid State Disk support:
  • MCSI "Prom Disk", EPROM to 1MB, Flash EPROM to 512 KB, Atmel Flash to 512 KB, SRAM to 512 KB, & NOVRAM to 512 KB

• Two software-configurable RS-232/422/485 serial ports
  • 16550 compatible UARTs for high-speed
  • Termination resistors for RS-422/485
• Parallel port
  •  SPP, PS/2 bi-directional, & ECP
• CAN bus
  • Intel 82527 CAN controller
  • Up to 1 MB/s data rate
  • Isolated ISO11898/2/ CAN interface 
  • Isolation up to 750Vac-rms
  • 82C251 CAN transceiver
• Digital I/O
  • 8 bit I/O
• Utility port
  • PC-AT compatible keyboard port
  • Speaker (0.1W output) port
  • Hardware Reset input
  • Battery input for Real Time Clock
  • Watchdog timer
• Power I/O
  • Access to PC/104 Bus power pins
  • Gnd, ±12 & 5 VDC

• RTD Enhanced BIOS with built-in SETUP and Quick Boot Mode Installed
• Fail Safe Boot Mode using embedded ROM-DOS
• Includes ROM-DOS , SSD software, utilities, and example programs.
• Compatible with most x86 operating systems:
• MS-DOS, ROM-DOS, PC-DOS
• Windows (95, 98, and NT 4.0)
• Linux (desktop and real-time versions)
• RTOSes such as QNX, VxWorks, and Windows CE

• Dimensions: 90.17 mm L x 95.89 mm W (3.550 in L x 3.775 in W)
• Weight: Approximately 0.10 Kg (0.22 lbs.)
• Operating temperature: -40 to +85 °C: 0-90% humidity, non-condensing
• Storage temperature: -55 to +125 °C
• MTBF: 115,000 hours typical
• Power requirements 66 MHz: 4.9 W @ 5 VDC typical with 16MB DRAM

• Cable Kit XK-CM32

• Hardware Manual
• Drivers and Example Programs
• Software Manual(s)
• Application Notes

Ordering Information

Copyright © 1998-2006 RTD Embedded Technologies, Inc.  All rights reserved.