PC/104 Low Power Intel™ 486DX
 HiRel cpuModule™ & Controller
CMi6486DX66HR
Two Serial Ports, SSD, IDE & Floppy Controller, ISA Expansion Bus

Operating Temperature -40° to +85°C

	Featuring Fail Safe & Quick Boot Modes
	Floppy
COM2			COM1
IDE			Parallel
			Utility: Keyboard Speaker Battery Reset
	Power
	CMi6486DX66HR-32  cpuModule™ Solder-tail expansion bus, vertical  I/O & feed-thru I/O connectors available on request
ISA    (PC/104)
	with standard Heatsink installed
	Featuring "BIOS Quick Boot" Mode

• 66 MHz @ 3.3 volt 486DX processor Intel™
• 16 or 32MB surface mount DRAM on-board
• Rugged Passive Heatsink
• 32 Pin SSD Socket Supports: SRAM, Flash & EPROM
• Software selectable RS-232/422/485
• Virtual Device Mode and Flash BIOS with Quick Boot Mode Installed
• Windows® CE Certified
• Mating Connectors
• Standard 10-pin 0.1" DIL header (Utility, COM1, COM2)
• Standard 8-pin 0.1" DIL header (Power)
• Standard 26-pin 0.1" DIL header (Parallel)
• Standard 34-pin 0.1" DIL header (Floppy)
• Standard 40-pin 0.1" DIL header (IDE)

Features:

• Complete PC-compatible motherboard, only 4 x 4"
• On-board IDE Drive controller
• On-board Floppy Drive controller
• Stackable 104-pin PC/104 AT bus
• Internal math coprocessor
• 16KB internal cache
• Built-in SETUP program
• BIOS with enhancements for nonvolatile configuration, Quick Boot Mode Installed, Solid State Disk & virtual device support
• 1024-bit EEPROM (user bits)
• 3 timer/counter channels
• 7 DMA channels
• 14 interrupt channels
• 32-pin DIP socket for Solid State Disk support:
  • MCSI "Prom Disk", EPROM to 1MB, Flash EPROM to 512 KB, Atmel Flash to 512 KB, SRAM to 512 KB, & NOVRAM to 512 KB

I/O:

• Two software-configurable RS-232/422/485 serial ports
  • 16550 compatible UARTs for high-speed
  • Termination resistors for RS-422/485
• Parallel port
  •  SPP, PS/2 bi-directional, & ECP

• Standard Floppy

  • Floppy Controller Interface

• Standard IDE

  • (Integrated Drive Electronics) hard drive interface

• Utility port
  • PC-AT compatible keyboard port
  • Speaker (0.1W output) port
  • Hardware Reset input
  • Battery input for Real Time Clock
  • Watchdog timer
• Power I/O
  • Access to PC/104 Bus power
  • Gnd, ±12 & 5 VDC

• RTD Enhanced BIOS with built-in SETUP and Quick Boot Mode Installed
• Fail Safe Boot Mode using embedded ROM-DOS
• Includes ROM-DOS , SSD software, utilities, and example programs.
• Compatible with most x86 operating systems:
• MS-DOS, ROM-DOS, PC-DOS
• Windows (95, 98, and NT 4.0)
• Linux (desktop and real-time versions)
• RTOSes such as QNX, VxWorks, and Windows CE

• Dimensions: 90.17 mm L x 95.89 mm W (3.550 in L x 3.775 in W)
• Weight: Approximately 0.10 Kg (0.22 lbs.)
• Operating Temperature: -40° to +85°C: 90% humidity non-condensing
• Storage Temperature: -55° to +125 °C
• MTBF: 115,000 hours typical
• Power requirements 66 MHz: 4.5 W @ 5 VDC typical with 16MB DRAM

• Cable Kit XK-CM16

• Hardware Manual
• Drivers and Example Programs
• Software Manual(s)
• Application Notes

Ordering Information

Copyright © 1998-2006 RTD Embedded Technologies, Inc.  All rights reserved.