
PC/104-Plus
Low Power Intel Celeron™
HiRel cpuModule™ &
Controller
with APIC, ACPI & Advanced Digital
I/O (aDIO)
CME147786HX650HR
Serial Ports, USB, Ethernet, EIDE, SSD, SVGA, aDIO, ISA & PCI Expansion Bus
Standard Operating Temperature: -40ş to
+85ş C
|
Featuring Fail Safe, USB
& Quick Boot Modes |
|
|
Audio
COM1
multiPort:
Parallel
Floppy(*)
aDIO™
Utility: Keyboard Speaker Battery Reset
|
|
COM2
SVGA
2 USB
Ethernet 100Base-Tx 10Base-T |
|
|
|
|
Power
|
EIDE
PS/2 Mouse |
|
|
|
CME147786HX650HR-256 cpuModule™
(*) Interfaces only with RTD modified floppy drive
Solder-tail expansion bus, right-angle I/O &
feed-thru I/O connectors available on request
|
|
|
ISA (PC/104)
|
 |
PCI (PC/104+) |
|
|
with standard Mini Fan & Heatsink installed
Available with PC/104 ISA Expansion Bus Connector Only (PCI Expansion Bus
Connector Removed)
Specify 146786 instead of 147786
|
|
|
|
 |
|
|
|
Rugged Fanless IDAN™
& HiDAN™ Configuration
-40°C to +85°C
|
|
- 650 MHz, 1.10Vdc Intel Celeron
with thermal throttling
- 128,
256 & 512 Mbytes SDRAM
- 4 Bus Master Add-on Cards Supported
- Mini Fan Heatsink with Auto Fan control
- Passive Structural Heatsink & Heatpipes in
IDAN and HiDAN System
Configurations
- Advanced Programmable Interrupt Controller (APIC)
- RTD Enhanced Award BIOS with ACPI, Quick Boot and USB Boot
- Nonvolatile Configuration
- multiPort with Parallel Port, Floppy Drive Interface and 18-bit Digital I/O Port with Advanced Digital Interrupt Modes
- INTEL 82559 Fast Ethernet
- 10BASE-T and 100BASE-Tx
- Full Duplex support
- AC97 Audio Support
- AGP S3 Savage SVGA controller
- 64-bit AGP Hardware graphics-accelerator 2-32 Mbytes selectable shared
video memory
- DirectX & OpenGL 3D Accelerator
- 3.3V or 5V PCI bus signaling
-
32 Pin SSD Socket Supports:
SRAM, Flash, EPROM & 32MB DiskOnChip
-
32MB DiskOnChip installed unless otherwise
specified
- Two RS-232/422/485 Ports
- Two USB (Universal Serial Bus) Ports
- EIDE Controller with UltraDMA 33/66/100
- PS/2 Mouse Port
- Keyboard Port
- Speaker Port
- Mating Connectors
- Standard 4-pin 0.1" DIL header (PS/2 Mouse)
- Standard 10-pin 0.1" DIL header (Utility, COM1, COM2, SVGA, USB,
Ethernet)
- Standard 12-pin 0.1" DIL header (Power)
- Standard 26-pin 0.1" DIL header (multiPort)
- Standard 10-pin 2mm DIL header (Audio)
- Standard 44-pin 2mm DIL header (EIDE)
Features:
-
Complete PC-compatible motherboard
-
Stackable 104-pin PC/104 AT bus
-
Stackable 120-pin PC/104-Plus PCI bus
- 4 Bus Master Add-on Cards Supported
-
Supports MMX instructions
-
Math coprocessor
-
32KB L1 and 256KB L2 internal cache
-
Boot Block Flash BIOS with Quick Boot Option
-
Boot from USB Device
-
Nonvolatile configuration without battery
-
Y2K compliant real time clock (external battery required)
-
Watchdog timer
-
7 DMA channels
-
24 interrupt channels with APIC enabled (15 in legacy PIC mode)
-
3 timer/counter channels
-
High resolution 100 MHz APIC timer
- Advanced Configuration and Power Interface (ACPI)
- ACPI 1.0 Compliant
- Supported power down modes: S1 (Power On Suspend), S4 (Hibernate), and S5 (Soft-Off)
- CPU Clock Throttling and Clock Stop for C0 to C3 Support
- Also supports APM 1.2 for legacy power management
- Advanced Thermal Management
- Thermal Throttling reduces clock speed to prevent thermal runaway
- Auto Fan Control only runs fan when needed
- SMBus Temperature Monitor for CPU and board temperature
- 32-pin DIP socket for Solid State Disk support:
- Standard: 32MB DiskOnChip installed unless otherwise specified
- On request: MCSI "Prom Disk", EPROM to 1MB, Flash EPROM
to 512 KB,
Atmel Flash to 512 KB, SRAM to 512 KB, & NOVRAM to 512 KB
I/O:
Software:
-
RTD Enhanced Award BIOS with built-in SETUP, USB Boot and Quick Boot Mode
Installed
-
Fail Safe Boot Mode using embedded ROM-DOS
-
Includes ROM-DOS , SSD
software, utilities, and example programs.
-
Compatible with all x86 operating systems:
-
MS-DOS, ROM-DOS, PC-DOS
-
Windows (98, NT 4.0, 2000, XP, and XP Embedded)
-
Linux (desktop and real-time versions)
-
RTOSes such as QNX, VxWorks, and Windows CE

Physical
Attributes:
- Dimensions
- Board Size: 90.17 mm L x 95.89 mm W (3.550 in L x 3.775 in W)
- I/O Ext: 12.70 mm EL x 79.38 mm EW (0.350
in EL x 3.125 in EW)
-
Weight: Approximately 0.14 Kg (0.30 lbs.)
-
Standard Operating Temperature: -40° to +85°C: 90% humidity non-condensing
- Storage Temperature: -40° to +85°C
-
MTBF: 110,000 hours typical
-
Power requirements 650 MHz: 9.0 W @ 5 VDC Typical
Recommended Accessories:
Documentation and Software Downloads:
Ordering Information
| Part Number
| Description
| OEM Price
|
| CME147786HX650HR-128 |
128MB SDRAM cpuModule™ |
$1295 |
| CME147786HX650HR-256 |
256MB SDRAM cpuModule™ |
$1495 |
| CME147786HX650HR-512 |
512MB SDRAM cpuModule™ |
$1695 |
* 32MB DiskOnChip installed unless otherwise specified
*Available with PC/104 ISA Expansion Bus Connector Only (PCI Expansion Bus
Connector Removed)
Specify 146786 instead of 147786
Third Party Information
IDAN™ Systems
CPU Guide
PC104
Menu Accessories
Development Kits
Home
Copyright © 1998-2006 RTD Embedded Technologies, Inc. All rights reserved.