RTD Embedded Technologies, Inc. PC104 and PC104 plus embedded computers Home Page RTD Product Menu Single Board Computers Digital Signal Processing Frame Grabber SVGA Panel DVI MPEG Bluetooth WLAN 802.11 Cellular GSM GPRS GPS-Rail Ethernet Quad Serial CAN Bus USB 2.0 Modem PCMCIA GPS Hard Drives Power Supplies IDE & Floppy Up to 16 Bit Resolution 8 differential or 16 single ended inputs 16-bit 200 kHz throughput outputs FIFO buffer Channel Gain Table Pacer & Burst Clocks Programmable Gain Bit Programmable Opto-isolated Timer/Counters Incremental Encoders Servo Motor Control Synchro / Resolver DC/DC Isolated Avionics IDAN HiDAN HiDANplus Return to RTD's Home Page


dspModule™  Selection Guide

DSP Coprocessor: Texas Instruments TMS320C6202 & TMS320C6416 DSP
PC/104-Plus:  PCI and ISA Expansion Buses

      Featured Companion Hardware

   
DSP Accelerator: Texas Instruments TMS320C6202 & TMS320C6416 DSP
PCI-104:  PCI Expansion Bus & DSP Parallel PlatformBus 

        Featured Companion Hardware

PC/104-Plus Architecture TI C6x dspModules™

DSP Coprocessor 
PC/104-Plus 
 Texas Instruments TMS320C6202 & TMS320C6416 DSP Processor
JTAG, SyncBus, McBSP Serial Port, & aDIO
PCI & ISA Expansion Buses
High Reliability (HR) -40º to +85º C
Extended Reliability (ER) -20º to +70º C

General Specs

 PROCESSOR:  TMS320C6202 233 MHz 
                        or TMS320C6416 1 GHz and 600 MHz
 MEMORY: 16, 32, 128, or 256 MB SDRAM
 FLASH: 2 MB
 EXPANSION BUSES: PCI and ISA Expansion Buses
 I/O PORTS:  JTAG, SyncBus, McBSPs,  Serial Ports & Audio
 I/O CONNECTORS: .100" X .100" Headers 
 SOFTWARE:  Drivers, Example Programs, and Libraries for DOS and Windows
 POWER:  Listed below @ 5 VDC typical 
PC/104-Plus MHz | MIPS | McBSP | RS-232/422/485 | SyncBus | aDIO | Audio | Watts OEM
 SPM6030HR-233-16    233    1864         3                                                  1                                     3.0W $ 795
 SPM176430HR600-32    600    4800         3                                                  1                                     2.7W $ 895
 SPM176430ER1000-32   1000   8000         3                                                  1                                     5.4W $ 1195
 SPM176431HR600-32    600    4800         1                        2                                       7            1       2.7W $ 995
 SPM176431ER1000-32   1000   8000         1                        2                                       7            1       5.4W $ 1395

PCI-104 Architecture TI C6x dspModules™

DSP Accelerator 
PCI-104 
 Texas Instruments TMS320C6202 & TMS320C6416 DSP Processor
JTAG, SyncBus & Three McBSP Serial Ports
PCI & PlatformBus Expansion Buses
High Reliability (HR) -40º to +85º C
Extended Reliability (ER) -20º to +70º C

General Specs

 PROCESSOR:  TMS320C6202 233 MHz 
                        or TMS320C6416 1 GHz & 600 MHz
 MEMORY: 16, 32, 128 or 256 MB SDRAM
 FLASH: 2 MB
 EXPANSION BUSES: PCI Expansion Bus and PlatformBus 
 I/O PORTS:  JTAG, SyncBus & Three McBSP Serial Ports
 I/O CONNECTORS: .100" X .100" Headers 
 SOFTWARE:  Drivers, Example Programs, and Libraries for DOS, Windows, and Linux
 POWER:  Listed below @ 5 VDC typical 
Part Number MHz | MIPS | McBSP | RS-232/422/485 | SyncBus | aDIO | Audio | Watts OEM
 SPM6020HR-233-16   233    1864         3                                                  1                                     3.0W $ 795
 SPM186420HR600-32   600    4800         3                                                  1                                     2.7W $ 895
 SPM186420ER1000-32  1000   8000         3                                                  1                                     5.4W $ 1195

DSP PlatformBus dataModule®

DSP PlatformBus dataModule®
 Analog interface with SyncBus & McBSP
Operating Temperature: -40°C to +85°C

Part Number Description OEM

 AIM6020HR

  ANALOG INPUTS:  2 Channel 12-bit, 1.25 MHz
 ANALOG OUTPUTS: 2 Channel, 12 bit, 200 kHz throughput
 ANALOG FILTER: Programmable anti-aliasing filter 
 EXPANSION BUSES: PlatformBus
 I/O PORTS:  JTAG, SyncBus & McBSP
 I/O CONNECTORS: .100" X .100" Headers 
 POWER:  1.0 W @ 5 VDC typical 

$  595

 

DSP PC/104-Plus dataModule® with McBSP Serial Ports

PC/104-Plus HighRel Analog & Digital I/O dataModule® with
Direct SyncBus & McBSP Link
Operating Temperature: -40° to +85°C
Part Number Description OEM

 SDM7540HR-1

Autonomous SmartCal™ : Software independent on-demand auto-calibration by onboard Texas Instruments TMS320F2812 DSP
BUS MASTERING: Master or Target Only
ANALOG INPUT:  12-bit, 1.25 MHz, 8 differential or 16 single ended, 1K FIFO buffer, 1024 entry channel gain table, pacer & burst clocks data markers, & programmable gain of 1, 2, 4, 8, 16, 32 & 64
USER TIMER/COUNTERS: Three 16-bit 
DIGITAL I/O: 16 buffered TTL/CMOS lines. Two independent ports of  8-Bits each. Port 0 is bit direction programmable. Port 1 is byte direction programmable. Advanced interrupt modes and bit masking. 
ANALOG OUTPUT: Two channel, 12 bit, 200 kHz throughput, independent 1 K FIFO buffers
I/O PORTS:  SyncBus & McBSP Serial Ports
SOFTWARE: Drivers and Examples for DOS, Windows, and Linux. Source code provided
I/O CONNECTORS: One 26 pin .100" x .100" Header (analog)
                                     One 40 pin .100" x .100" Header (digital)
                                     One 10 pin .100" x .100" Header (McBSP)
                                     One 10 pin .100" x .100" Header (SyncBus)

$ 1295

 SDM7540HR-8

 SDM7540HR-1 with 8K FIFO buffer

$ 1395
 DM7520HR-1

BUS MASTERING: Master or Target Only
ANALOG INPUT:  12-bit, 1.25 MHz, 8 differential or 16 single ended, 1K FIFO buffer, 1024 entry channel gain table, pacer & burst clocks data markers, & programmable gain of 1, 2, 4, 8, 16 & 32
USER TIMER/COUNTERS: Three 16-bit 
DIGITAL I/O: 16 buffered TTL/CMOS lines. Two independent ports of  8-Bits each. Port 0 is bit direction programmable. Port 1 is byte direction programmable. Advanced interrupt modes and bit masking. 
ANALOG OUTPUT: Two channel, 12 bit, 200 kHz throughput, independent 1 K FIFO buffers
I/O PORTS:  SyncBus & McBSP Serial Port
SOFTWARE: Drivers and Examples for DOS, Windows, and Linux. Source code provided
I/O CONNECTOR: 3M 68 pin .50" x .100" Tripolarized Shrouded Header mates with .050" x .100" Tripolarized IDC Mini Socket 

$ 895
 DM7520HR-8 DM7520HR-1 with 8K FIFO buffer

$ 995

DSP PCI-104 dataModule® with McBSP Serial Ports

PCI-104 HighRel Analog & Digital I/O dataModule® with
Selectable Bus Mastering, Direct SyncBus & McBSP Link to Serial Port
Operating Temperature: -40° to +85°C
Part Number Description OEM

 SDM8540HR-1

Autonomous SmartCal™ : Software independent on-demand auto-calibration by onboard Texas Instruments TMS320F2812 DSP
BUS MASTERING: Master or Target Only
ANALOG INPUT:  12-bit, 1.25 MHz, 8 differential or 16 single ended, 1K FIFO buffer, 1024 entry channel gain table, pacer & burst clocks data markers, & programmable gain of 1, 2, 4, 8, 16, 32 & 64
USER TIMER/COUNTERS: Three 16-bit 
DIGITAL I/O: 16 buffered TTL/CMOS lines. Two independent ports of  8-Bits each. Port 0 is bit direction programmable. Port 1 is byte direction programmable. Advanced interrupt modes and bit masking. 
ANALOG OUTPUT: Two channel, 12 bit, 200 kHz throughput, independent 1 K FIFO buffers
I/O PORTS:  SyncBus & McBSP Serial Ports
SOFTWARE: Drivers and Examples for DOS, Windows, and Linux. Source code provided
I/O CONNECTORS: One 26 pin .100" x .100" Header (analog)
                                     One 40 pin .100" x .100" Header (digital)
                                     One 10 pin .100" x .100" Header (McBSP)
                                     One 10 pin .100" x .100" Header (SyncBus)

$ 1295

 SDM8540HR-8

 SDM8540HR-1 with 8K FIFO buffer

$ 1395

PC104 Menu   /  Accessories   /   Development Kits   /   Systems   /   Home

Copyright © 1998-2008 RTD Embedded Technologies, Inc.  All rights reserved.