CM17407HR and CM18407HR
PC/104-Plus and PCI-104 USB 2.0
Five Port Network Peripheral Module

USB1		USB5   USB4 USB3   USB2
PC/104-Plus CM17407HR USB 2.0 Network Hub Module
USB1		USB5   USB4 USB3   USB2
PCI-104 CM18407HR USB 2.0 Network Hub Module
Rugged IDAN® Configuration

Features:

• Five Independent USB 2.0 Network Connections
• USB1 provides 2.0A @ +5V
• USB2-5 provides 500mA @ +5V
• 3.3V and 5V PCI signaling compatible
• Hi-Speed USB transfer speed modes: high-speed (480 Mbit/s), full-speed (12 Mbit/s) and low-speed (1.5 Mbit/s) on any channel
• Full Duplex support

• Chipset

  • NEC 720101 USB 2.0 Controller
  • Bus Mastering

I/O:

• Standard USB-Type A or 10-pin twisted pair connectors
• PCI stack through bus
• ISA 16-bit stack through bus (CM17407HR only)

Software:

• Uses standard EHCI and OHCI drivers built into modern operating systems.
• USB 2.0 natively supported under:
  • Windows 2000 Service Pack 4
  • Windows XP Service Pack 1
  • Windows Server 2003
  • Windows CE .NET 5.0
  • Linux kernel 2.4.22
  • Linux kernel 2.6
  • QNX Neutrino 6.3
  • VxWorks 6.0

Physical Attributes:

• Size: 90mm L x 96mm W x 15mm H (3.6"L x 3.8"W x 0.6"H)
• Weight: Approximately 0.18 lbs. (0.08 Kg).
• Operating Temperature -40°C to +85°C: 90% humidity non-condensing
• Storage Temperature -55°C to +125°C
• MTBF:  3,848,671 hours
• Power Requirements: 0.5 W @ +5 VDC typical (Board Only)
  • Note:  Power consumption can increase depending upon the type and number of USB devices attached.

Documentation and Software Downloads:

• Hardware Manual
• Drivers and Example Programs
• Software Manual(s)
• Application Notes

Ordering Information