GPS Receivers with Linx Engines
GPS Receiver with Linx RXM-GNSS-TM GPS Engines and Inertial Sensor
Operating Temperature -40° to +85°C
Rugged IDAN system configurations available. |
Key Features
- PC/104 form factor
- Bus Structure Options:
- PCIe/104 (GPS35162HR)
- PCIe universal expansion bus (Type 1 or Type 2)
- PCI/104-Express (GPS25162HR)
- PCIe universal expansion bus (Type 1 or Type 2)
- PCI pass-through expansion bus
- PCIe/104 (GPS35162HR)
- Available in stackable, rugged enclosures
- PCIe x1 interface (Gen 2, 5 GT/s)
- PCIe link repopulation allowing increased PCI Express stack capacity
- Linx RXM-GNSS-TM GPS engine
- L1 1575.42MHz, C/A code
- 33-channel satellite tracking
- Position accuracy: 2.5m
- Time accuracy of ±11ns
- 1Hz update rate (configurable up to 10Hz)
- Tracking sensitivity down to -164 dBm
- Protocol: NMEA-0183 ver 4.10
- Constellation System Support:
- GPS
- GLONASS
- GALILEO
- QZSS
- DGPS support:
- (SBAS) Satellite-Based Augmentation System
- (RTCM) Radio Technical Commission for Maritime Services
- (WAAS) Wide-Area Augmentation System
- (EGNOS) European Geo-Stationary Navigation System
- (MSAS) MTSAT Satellite-Based Augmentation System
- (GAGAN) GPS-Aided Geo-Augmented Navigation
- Supports active (+3.3V or +5V) and passive antennas
- Requires only +5 VDC for operation
Description
The GPS25162 and GPS35162 are PC/104 modules that utilizes the Linx RXM-GNSS-TM GPS receiver. This low-power solution supports NMEA-0183 protocol. Support for +3.3V and +5V active antennas is provided. The GPS25162HR and GPS35162HR utilize one PCIe x1 link to provide two 16C550 compatible serial ports: one for GPS and one for onboard serial connector.
Connector Interface
- Stackable Buses
- PCIe universal expansion bus (Type 1 or Type 2)
- PCI expansion bus (GPS25165 only)
- External I/O Connectors
- 10-pin right-angle header
- GPS TX monitor
- GPS external battery
- GPS - 1 PPS signal
- 10-pin right-angle header
- Serial Port
- MCX antennae connector
- GPS Active/Passive Antenna
- 10-pin right-angle header
Software
- GPS data available to CPU via COM port interface
- PCIe COM port drivers available for:
- Windows XP, Windows 7 (32/64 bit), and Windows 10 (32/64 bit)
- Linux (driver built into kernels > 3.8)
Recommended Accessories
Physical Attributes
- Dimensions
- Length (L): 3.775 inches (95.89 mm)
- Width (W): 3.550 inches (90.17 mm)
- Stand-off Height: 0.600 inches (15.24 mm)
- Weight: Approximately 0.14 lbs. (0.06 Kg)
- Standard Operating Temperature, 90% humidity non-condensing: -40 to +85°C
- Storage Temperature: -55 to +125°C
- Power Requirements: TBD
Documentation and Downloads
- Hardware Manual
- Rugged Enclosure (IDAN) Datasheet
- Software Downloads
Ordering Information
Part Number | Description | Value OEM |
---|---|---|
GPS35162HR | PCIe/104 GPS Receiver with Linx RXM-GNSS-TM GPS Engine | $795 |
SK-GPS35162HR | Starter kit including GPS35162HR, adapter cable, and antenna | $845 |
GPS25162HR | PCI/104-Express GPS Receiver with Linx RXM-GNSS-TM GPS Engine | $845 |
SK-GPS25162HR | Starter kit including GPS25162HR, adapter cable, and antenna | $895 |
RTD Embedded Technologies, Inc.
Designed and Made in the USA
[email protected] | +1-814-234-8087